Meet the original Stegosaurus Dienosaur! This little friend will safely guard or display your dice (one standard 7-piece set), ready for your next adventure.
TECHNICAL DETAILS
This is an officially licensed print from RachMakes and has been printed on a BAMBU LABS A1 3D Printer using high quality PLA Filament.
The Stegosaurus Dienosaur has been tested by RachMakes based on the sizes below however dice, like dinosaurs, come in all different shapes and sizes so there is no guarantee your dice may fit as described.
D4 - 17mm
D6 - 15.8mm
D8 - 15.4mm (24.2mm point-to-point)
D% - 16.3mm (22.2mm point-to-point)
D10 - 16.3mm (22.2mm point-to-point)
D12 - 18mm
D20 - 19.9mm
The Stegosaurus Dienosaur measures about 22cm long, 10cm tall and 8cm wide when printed standard size.
Please note that Mythril Foundry dice are approximately 10% larger than the standard factory dice sizing listed above so if you are buying this item specifically to fit Mythril Foundry dice, you may need to purchase a scaled up item to suit.
DISCLAIMER
Mythril Foundry strives to create high quality products however due to the nature of being 3D printed, these dice guardians may not be factory perfect. Upon close inspection you may find some small but visible signs of the crafting process such as layer lines, support marks or rough edges, small printing errors, tiny internal (rare) and/or other minuscule imperfections of this nature. Any major marks for pre-printed items will be listed below and pictured (where possible) for your consideration prior to purchasing however this may not be possible for print-to-order items.
Please note that returns/refunds based on the above will not be accepted.